I ordered 500 cases. (over sixty cents a pop)
I've got some OFB, I guestimate 100+ but I've got to sort them out of half a 5 gallon bucket of range brass and make certain none of the empties wound up back in the boxes.
I've got 1000 Xtreme 325 grain blems (and 500 first quality) that should load to the Alexander Arms 335 Rainier data OR probably load to the high end of AA 335 Speer data.
I've also got several boxes of Hornady 350 grain XTP MAGs I got a decent deal on, a hundred Lehigh 325gr solid copper 'penetrators', and a box or two of 400 grain FPs.
4# jug of Lil Gun, about 8# of H110, a lb of IMR 4227 and 4 to 8#s of 2400.
A K and a half of mag pistol primers.
I've got a set of Lee dies.
Probably start slow and load 10-20 of the Blems.
Do the same thing with the XTPs.
Maybe load the Lehighs in sets of 5.
Once I've got a load for each I'm thinking load a hundred XTPs, maybe 50 of the Lehighs and finish out the brass with the Xtremes for practice and fun. Not that they shouldn't still do the job if push came to shove.
It's been a while since I've had time to load. Under the current CA ammo rules this caliber is a pain since you practically have to order it into a shop and then go in and pay them extra to receive it. Local shop I was in last week charges $20 to receive it up to $400 invoice at which point they charge 5%.
This stuff typically runs $1.25 to $1.50 per round plus shipping and handling through the net and more if you find it on the shelf or have to have it ordered through a retailer. That's for the mundane plated ammo, Loaded with XTPs or the Lehigh projectiles it gets a lot more expensive fast. I won't be saving a lot but I should be running about $1.10 for the XTPs and maybe $.90 or so for the plated stuff.