CJ Stock bolt... not too secure.
- retAFShooter
- Posts: 164
- Joined: 27 Jul 2014 17:45
- Location: Maryland
- Has thanked: 64 times
- Been thanked: 39 times
CJ Stock bolt... not too secure.
I had a problem with the bolt holding the stock on the Circuit Judge. I noticed it was loose the last time I fired it. When I got home, I tried to tighten it a few turns, but it went clean through the slim layer of wood that was holding it. Braztech didn't do a good job on this, in fact I think it is a design flaw. They need a better solution to that bolt connection. In lieu of sending it back and getting the same flawed design, I decided to fix it myself. I found a longer bolt and mounted the washer on the outside. I had to do some dremel work on the little plastic cover in order to fit the bolt head underneath.
You do not have the required permissions to view the files attached to this post.
Check out my YouTube Channel: https://www.youtube.com/user/RetAFShooter
- retAFShooter
- Posts: 164
- Joined: 27 Jul 2014 17:45
- Location: Maryland
- Has thanked: 64 times
- Been thanked: 39 times
Re: CJ Stock bolt... not too secure.
By the way, the bolt is a 4mm one.
Check out my YouTube Channel: https://www.youtube.com/user/RetAFShooter
- akuser47
- Founding Member
- Posts: 5070
- Joined: 12 Feb 2012 11:43
- Location: ohio
- Has thanked: 1266 times
- Been thanked: 482 times