How to grind the lower dentent inside the receiver?
-
- 250 Shots
- Posts: 261
- Joined: 09 Dec 2012 09:38
- Location: Bainbridge GA
- Has thanked: 10 times
- Been thanked: 21 times
Re: How to grind the lower dentent inside the receiver?
I was looking at a Winchester 92 a while back in 32-20 and I think it had the same arrangement as the Rossi 92 in 357 Magnum. Also had one of the Japanese 92s in 357 and it had the some thing.
-
- 2000 Shots
- Posts: 3942
- Joined: 04 Feb 2014 05:30
- Location: SoCal Loco
- Has thanked: 137 times
- Been thanked: 610 times
Re: How to grind the lower dentent inside the receiver?
I've got one each of the Braztech .357Mag and .44 Mag both recent production.
The detent notch on the .44 is on the receiver. The detent on the .357 is on the LHS cartridge guide.
Steve's vid is done using one of the stainless .38/357 guns before they started putting the safety on the bolt and it is the same.
The carrier on the .44 is narrower at the forward end with the detent in the thicker portion about halfway back where it there is additional 1/8" in width on the LHS. The .357 carrier is constant width front to back.
I haven't ripped into them yet but that's my next project.
The detent notch on the .44 is on the receiver. The detent on the .357 is on the LHS cartridge guide.
Steve's vid is done using one of the stainless .38/357 guns before they started putting the safety on the bolt and it is the same.
The carrier on the .44 is narrower at the forward end with the detent in the thicker portion about halfway back where it there is additional 1/8" in width on the LHS. The .357 carrier is constant width front to back.
I haven't ripped into them yet but that's my next project.
-
- 1000 Shots
- Posts: 1650
- Joined: 03 May 2013 10:14
- Location: LaGrange Georgia
- Has thanked: 7 times
- Been thanked: 340 times
Re: How to grind the lower dentent inside the receiver?
I wonder when they will start making injection molded barrels?....I wouldn't put it past them to try it.
Don Huff
to bad those that know it all, cant do it all!
16" SS 92 357
20" BL 92 357
20" SS 92 44
20" BL 92 44
20" Bl 92 45C
20" Bl 92 454
SS Rio Grande 30-30
Bl Rio Grande 45-70
to bad those that know it all, cant do it all!
16" SS 92 357
20" BL 92 357
20" SS 92 44
20" BL 92 44
20" Bl 92 45C
20" Bl 92 454
SS Rio Grande 30-30
Bl Rio Grande 45-70